Microsoft Hotfix KB918118 Problems

• Add to Bookmarks Send to Peer

  Microsoft Hotfix KB918118 Problems
  March 1, 2007, 11:46 AM Kevin Schneider

  A recent hotfix from Microsoft has caused problems with entering text in Inventor's drawing manager.
  Check out this KB article for instructions and a fix.
  
  
  

  2 Comments | Add Comment >

Comments

• 

  March 13, 2007 09:12 AM Harold Clark

  The recommendations for the hotfix on Microsoft update KB918118 include two options: one for users of Inventor Series 11 Service Pack 2 and one for Inventor Series 11 DWF Extension Service pack 2. Since I have not had any problems up until the above mentioned Microsoft udate, I have not installed any service packs. The technical support personnel at my Autodesk reseller recommended that I not install any service packs if I was not having any problems. The hotfix does not offer a solution for users who are not using any of the service packs. Which version of the hotfix do I install? HRC

• 

  March 14, 2007 07:11 PM Kevin Schneider

  I am looking into this and will let you know an answer.